Left Side Front Floor & Several Cutouts
- Details
- Category: Restoration Section
- Published on Monday, 13 May 2013 16:47
- Written by Klaus
- Hits: 145085
alt="side cowl panel clamped back again to check" src="/klaus12/klaus07s.jpg" width=90 alt="Firewall extension going in" src="/klaus12/klaus08s.jpg" width=90 alt="left torque box mostly out" src="/klaus12/klaus09s.jpg" width=90 alt="Inside view everything primered again" src="/klaus12/klaus10s.jpg" width=90 alt="Easy working without the inner rocker panel" src="/klaus12/klaus11s.jpg" width=90 alt="Just see the numerous factory spotwelds to the torque box" src="/klaus12/klaus12s.jpg" width=90
Christines Restoration Pages
Left Side Front Floor & Several Cutouts
|
This page is showing some work nobody likes very much. A lot of original sheetmetal has to come out. Starting with the firewall extension and the side cowl panel it goes further with the torque box and the floor panels. We did the cutout of the a-pillar only to reach the spotwelds under it. That's not only a way to make this rocker work easy, but it's also the only way to make everything rustfree underneath. You will see later that nothing will be visible after finishing work. |
Christines Body Page 12 of 22
Back to Overview Bodywork | Previous Page | Next Page
 |
 |
 |
|
Old front floor LH already out
|
Sometimes those repro panels are fitting fine
|
Final measuring before welding
|
 |
 |
 |
|
What ever it is???
|
Inner rocker completly out
|
A-pillar taken out
|
 |
 |
 |
|
Cowl panel clamped back again to check
|
Firewall extension going in
|
Left torque box mostly out
|
 |
 |
 |
|
Inside view everything primered again
|
Easy working without the inner rocker panel
|
Just see the numerous factory spotwelds to the torque box
|
Page 12 of 22